SC Quick Optical Fiber Field Installable Connector No Need Epoxy SM TPU Repeat Use

SC Quick Connector Optical Fiber Drop Cable Termination 55mm No Need Epoxy SM TPU Repeat Use

Fast field-installable connectors are factory pre-polished connectors that completely eliminate the need for hand polishing in the field. Proven mechanical splice technology ensuring precision fiber alignment, a factory pre-cleaved fiber stub and a proprietary index-matching gel combine to offer an immediate low loss termination to either single-mode or multimode optical fibers.

Fast connectors are compatible with 250µm and 900µm optical fibers, as well as 900µm, 2mm and 3mm cordage. All primary fiber types are supported, and each connector is color coded per industry-standard requirements to aide in identification during and after installation. A factory-installed wedge clip (included with each connector) is removed and discarded upon completion of the termination.

Features

No epoxy required

Fiber can be reseated

Pre-stubbed, factory-polished ferrule

Precision mechanical alignment insures low loss

VFI can be used to confirm fiber is installed properly

Meets TIA/EIA 568A performance requirements

Meets TIA/EIA 604 (focis) connector interface requirements

Applications

Premise environments

Connections at the desk for LAN environments

Direct equipment termination

Fiber to the Subscriber (FTTx) applications

Repair and replacement requirements

Equipment test leads

Patch panels

 singlemode APC or PC both can do. Fiber moe:  APC green house,PC blue house.

gray part is clip for repeat use, it can be take off by hand, round boot is screw on and off

 3mm round or 2x3mm figure-8 drop cable can insert from boot, high quality ceramic ferrule and pre-polished fiber inside.

Specification

Mechanical performance requirements